Tuesday, May 24, 2011

Not able to get IP address after deep sleep

Not able to get IP address from previously connected AP after its resumed from deep sleep,the issue was more due to filters is enabled.

If Filters are enabled these are the messages you get
./wl pkt_filter_list 1
./wl pkt_filter_list 1
Num filters: 1

Id          :100
Negate      :0
Type        :0
Offset      :0
Pattern len :3
Mask        :0xffffff
Pattern     :0xffffff

To disable filter use this
./wl pkt_filter_enable 100 0

No comments:

Post a Comment